Pattern says:
Needle 1: follow Chart A, repeat 7 times in total. Needles 2 and 3: follow Chart B
This is right at the beginning after you do the cuff, where it says, LEG. Before that for the cuff you cast on 66 and had 30 sts on needle #1, 18 on #2, and 18 on #3. You keep that same set up as you go into the leg. (Chart A is called" front of leg", chart B " back of leg".)
Chart A is worked over needle #1, That chart has 30 sts (as N#1 has), and Chart B, which is under charts A and C, has 36 stitches (the total of needles #1 and #2–18 each). I don’t get the rounds because chart A has 9 rounds and it says repeat it 7 times, that would be 63 rounds. Chart B has 55 rounds. :?? So they don’t seem to jive.
I assumed that since chart A is suppose to be repeated 7 times at 9 rows, gives me the 36 rows which is the same number of numbered rows on chart C,
No 9X7 is 63, not 36.
Above it says to work Chart A over needle #1, and Chart B over the 36 sts on needles #2&3 for the leg.
I can’t see anywhere that it tells you to use Chart C, but it seems it would be on page 2 in the center column where it gives a new set up and has the FOOT.
18 sts on Needle 1, 30 sts on Needle 2; 18 sts on Needle 3.
foot
Continue in established pattern –working st st over Needles 1 and 3(sole) and following Chart B over Needle 2, until 2 inches before desired length of foot.
This says to use Chart B, but it seems to me it should say chart C. Needles 1 &3 are done in St st, for the sole, and needle 2 is for the top of foot, as far as I can tell. Chart C is labeled “top of foot” and has the 30 sts they indicate need to we worked on this needle #2.
Is there any place you can ask about this where the pattern comes from, things don’t quite figure to me.