I’m working on this sweater:
and hve come to the collar shaping/placket.
here are the insructions:
Right Placket and Collar: With smaller needles, cast on 14 sts.
Row 1 (RS): Sl 1, (p1, k1) 6 times, p1.
Row 2: * K1, p1, rep from * across. Rep these 2 rows until piece measures 4” from beg, end on WS. Mark end of last row for beg of collar.
Inc Row (RS): Work to last st, M1p, k1 – 15 sts. Inc 1 st 1 st in from same edge EVERY row 15 times more, working incs into ribbing – 30 sts. Inc 1 st 1 st in from same edge every RS row 13 times – 43 sts. Inc 1 st 1 st in from same edge every other RS row 5 times – 48 sts. Work even in ribbing as established until collar, when slightly stretched, measures 9(9 1/2-10-10 1/2-11)” above marker, end on WS. Mark beg and end of last row. Work even for 4 rows.
Note: Short rows are worked to give shaping to the collar. When working these rows you will work part way across a row, turn, sl 1, then work back to the beginning.
Short Rows: Row 1 (RS): Work 42 sts in ribbing, turn, sl 1, then work to end. Work 4 rows even.
Row 2 (RS): Work 38 sts in ribbing, turn, sl 1, then work to end. Work 4 rows even. Continue in this manner to alternate short rows and even rows, working 4 less sts each short row until short side of collar measures 5 1/2” above markers, end on WS. Sl 48 sts onto holder. Mark placement of 2 buttons on placket, one 1” up from cast-on edge and the other just below beg of collar.
The only part i’m confuse about are the short rows. i understand the short row part but then it says to work even 4 rows. does this mean the entire row? or just the short rows?