I have been working on the Pelica knitting pattern and have just reached the bit where I need to join front and back but I am confused as to how to do this and struggling to understand the instructions in the pattern.
Is this the frst time you have seamed shoulders and you need help with how to line them up? Or how to seam?
Or do you know how to do this already but something about the instruction for this pattern is puzzling you?
It might help to type out the part you are stuck on, not the whole pattern, just a few lines so we can help.
Are you struggling with the rotation of the i-cord? There have been a few questions about that in the past!!
The last three stitches of each piece will be edge i-cords. So when you get to the last three on the left front, you need to work the last stitch of the three first, the middle stitch second, and the first stitch last. The counter clockwise phrase means that when you moved the third stitch to the first position, you bring it across the front of stitches 1 and 2 rather than behind them. Think of a cable crossing - front right!
Thanks both for your replies! Really appreciated .
I muddled through the shoulders, but now I am trying to join front and back. The stitches are currently on the left front. Should I get another needle to pick up the stitches from the front right? Really not sure where to go from here! This is what the pattern says:
“Place right front sts, back sts and left front sts on a circular needle. Your first row will be a right side row and you can work with the yarn from the Left front panel.”
Ah, ok. You are working top down and joining the two fronts and the back, under the arms?
Do you have the back stitches and the right front stitches on hold, maybe on a strand of yarn or a spare cable?
If they are on an interchangable cable you can put a needle on it and work the stitches straight off that cable. The needle tip can be a size smaller for this (it is important the working needle is the correct size but you can work off of a smaller needle).
If the stitches are on a yarn strand I would suggest transferring them all onto a needle before working them but you don’t necessarily need an additional needle for this. If your left front stitches are already on a circular needle which is long enough to hold all the stitches (fronts and back) you can just slip each held stitch onto this needle without working it. Slip the back stitches onto the needle then slip the front right stitches on.
Begin working the row with the left front where your working yarn is attached.
So just to clarify - I have the back and right front stitches on hold and the left on circular needles. If I can fit the back and front on my circular needles (which I think I should be able to), I just slip the stitches on the needle that is towards the back. Should I have the working yarn at this end too? Currently it is near the front centre. I have attached a picture below.
Thank you once again for all your help so far! Its really really appreciated!
Yes, I think you’ve got it. When moving stitches onto your current circular make sure they go on in the right place. You will begin knitting where the yarn is currently and will work across this left front, and then reach back stitches, work across then reach right front stitches and work across. Then you will work flat back and forth.