Yes you can measure it in cm each time if you prefer.
First decrease after 3 cm then 4cm later (yes 7cm) then another 4 cm later (11 cm) and so on.
Don’t forget the decrease tip which is a seperate note at the beginning of the pattern.
Now is also the time to check you will like the length of the sleeve as written as it is possible to shorten or lengthen and adjust where the decreases are.
Brill thank you.
Now I did my first decrease at 3cm and am now a couple of rows along but I’m thinking I may have done it “wrong” but also not.
So reading instructions it’s marked in between two stitches and do the decreases on whatever the instruction says. Now what I’ve done is where I went to start the next row (9th row) I read the instructions as k2tg first so went back to end 8th and did that there then ssk on start of 9th. I’ve forgotten if they are actually the decreases as doing quickly off memory but wondered if should’ve started with ssk on beginning of 9th row then end of 9th row k2tg. But because it’s a spiral anyway I’m thinking it won’t actually matter that much.
1 Like
DECREASE TIP (for mid-under sleeves):
Decrease 1 stitch on each side of the marker-thread as follows:
Work until there are 3 stitches left before the marker-thread, knit 2 together, knit 2 (marker-thread sits between these 2 stitches), slip 1 stitch knit-wise, knit 1 and pass the slipped stitch over the knitted stitch (2 stitches decreased).
Sounds like you’ve done the right thing.
If you were working flat it would make sense to dec at beginning and end of the same row (they would align with seaming), but here the pattern says to work in the round and decrease near the end of the round and then at the beginning of the next round. This will be so the decreases look nice together rather than looking misaligned.
2 Likes